Written by Administrator
With Any Alarm System An RJ-31X Telephone Interface Is Recommended. This Ensures That The Burglar Can Not Take Your Telephone Off The Hook And Prevent Your System From Dialing Out.
The Following Steps Will Show You How To Install Your RJ-31X Jack.
* 1-Remove Your Existing Jack OR Telephone Wires From The Connecting Block You Ran Your Burglar Alarm RJ-31X Jack Telephone Wire To.
* 2-Connect Your RED & GREEN Wires From Your RJ-31X Jack To The Telephone Block That Your Phone Wires Used To Be Wired To. Thus Dedicating Dial Tone To Your Security System First.
* 3-Connect Your YELLOW & BLACK OR What Ever Second Pair You Used From Your RJ-31X To The Telephone Wires You Removed From Your Block Or Dial Tone.
* You Are Done: Now Your Security System Will Act As A Switch, Disconnecting Your Telephone's In The House From Your Security System.
* NOTE: The Same Applies Even If You Connect Your Alarm To Just 1-Telephone Jack In The House. Just Remember That Most RJ-31X Jacks Have Brown & Grey In Place Of Yellow & Black. Then Remove The Jack Wires From The Back Block And Connect Them To The Second Pair From The RJ-31X Jack.
* NOTE: If You Loose Dial Tone At Any Time, All You Have To Do Is Unplug The Wire From Your Security System To The RJ-31X Jack. This Will Disconnect Your Security System From Your Telephones And Allow The RJ-31X Jack To Act As The Switch Instead Of The Security System.
This Allows You To See If The Security System Is Locked Up Preventing Your Telephones From Working OR If Your Telephone Company Is Having Problems And Not Giving You Dial Tone To Your House
Wednesday, 10 June 2009 11:13
With Any Alarm System An RJ-31X Telephone Interface Is Recommended. This Ensures That The Burglar Can Not Take Your Telephone Off The Hook And Prevent Your System From Dialing Out.
The Following Steps Will Show You How To Install Your RJ-31X Jack.
* 1-Remove Your Existing Jack OR Telephone Wires From The Connecting Block You Ran Your Burglar Alarm RJ-31X Jack Telephone Wire To.
* 2-Connect Your RED & GREEN Wires From Your RJ-31X Jack To The Telephone Block That Your Phone Wires Used To Be Wired To. Thus Dedicating Dial Tone To Your Security System First.
* 3-Connect Your YELLOW & BLACK OR What Ever Second Pair You Used From Your RJ-31X To The Telephone Wires You Removed From Your Block Or Dial Tone.
* You Are Done: Now Your Security System Will Act As A Switch, Disconnecting Your Telephone's In The House From Your Security System.
* NOTE: The Same Applies Even If You Connect Your Alarm To Just 1-Telephone Jack In The House. Just Remember That Most RJ-31X Jacks Have Brown & Grey In Place Of Yellow & Black. Then Remove The Jack Wires From The Back Block And Connect Them To The Second Pair From The RJ-31X Jack.
* NOTE: If You Loose Dial Tone At Any Time, All You Have To Do Is Unplug The Wire From Your Security System To The RJ-31X Jack. This Will Disconnect Your Security System From Your Telephones And Allow The RJ-31X Jack To Act As The Switch Instead Of The Security System.
This Allows You To See If The Security System Is Locked Up Preventing Your Telephones From Working OR If Your Telephone Company Is Having Problems And Not Giving You Dial Tone To Your House
Last Updated on Tuesday, 01 September 2009 10:46